Ekip Dip Protection Release; Operator Interface; Introduction; Components Of The Interface - ABB SACE Emax 2 Series Installation, Operation And Maintenance Instructions

Ekip Dip protection release

1 - Operator interface

Introduction The operator interface of the Ekip Dip protection release allows you to:
Components of the interface The Ekip Dip operator interface appears as follows:
35 | © 2013 ABB | 1SDH001000R0002 - L7804
• Set the parameters relating to the available protections.
• View the status of the release and alarms.
• Connect to the frontal connector to communicate and perform the tripping test.
Figure 63
The following table provides a description of the components of the interface:
Position Type
A
B
C
LED
D
E
F
G
H
Protections:
thresholds
I
L
M
Protections: times
N
Or
P Settings
Q
Test
R
IMPORTANT: The figure above refers to a an Ekip Dip, LSIG version. In the
case of Ekip Dip versions LI or LSI, LEDs and dip-switches related to the
protections present are available.
Description
Protection LED L (alarm and trip)
Protection LED L (prealarm)
Protection LED S (alarm and trip)
Protection LED I (trip)
Protection LED G (alarm and trip)
Power LED (release powered and on)
Protection L dip-switch (threshold I1)
Protection S dip-switch (threshold I2)
Protection I dip-switch (threshold I3)
Protection G dip-switch (threshold I4)
Protection L dip-switch (time t1)
Protection S dip-switch (time t2 and type of curve)
Protection G dip-switch (time t4 and type of curve)
Neutral and Frequency dip-switch
Test pushbutton
Test connector
Ekip Dip protection release | 1 - Operator interface
ABB | SACE Emax 2