Ekip Touch Protection Trip Unit; Layout Of The Interface; Components Of The Interface - ABB SACE Emax 2 Series Instructions For Use Manual

Ekip Touch protection trip unit

1 - Layout of the interface

Components of the interface The operator interface for the Ekip Touch trip units appears as follows:
6 | © 2018 ABB | 1SDH001316R0002 - ECN000086018 - Rev. C
Figure 2
The following table provides a description of the parts of the interface:
Pos. Description
A Touchscreen display.
B Power LED, green.
C LED Warning, yellow.
D LED Alarm, red.
E The HOME key accesses the main page, or the initial page.
iTEST key. If the main page or a level 2 page is displayed (see below), whenever you press on it
the following pages are displayed in succession:
• List of Alarms, if there are any messages.
• Protection unit, with information on Mainboard and trip unit.
F
• Circuit-breaker, with information on the circuit-breaker.
• Last opening, with information on the last opening.
If the Trip Test item has been selected in the Test menu, it will execute the opening command
when pressed and held for at least 7 seconds.
G Test connector.
A
03:55
528.9A
L1
95.3V
U12
U12 U23 U31 L1 L2 L3 Ne
Ekip Touch protection trip unit | 1 - Layout of the interface
ABB | SACE Emax 2
B
C
D
E
F
G