System Configuration; Connection Of Power Cables And Ground Cables - Mitsubishi Electric GOT SIMPLE GS2110-WTBD User Manual

5.2.3

System configuration

■1. GOT
Use the following GOTs having a CE mark on the rating plate.
The following models are compliant with the EMC Directive at factory shipment.
When any GOT other than the following does not comply with the EMC Directive.
Product name
GS2110
GS2107
■2. Connection type
The following table lists the connection types compliant with the EMC Directive.
Ethernet connection
Direct CPU connection
Computer link connection
Other connections
(Connection with non-Mitsubishi PLC, inverter, servo amplifier)
*1
*2
5.2.4

Connection of power cables and ground cables

Carry out wiring and connect the power and ground cables according to the following instruction.
By the different wiring or connection method, the system may not comply with EMC Directive.
■1. Wiring method
For connection of power cables and ground cables, refer to the following.
Ground the frame ground terminal (FG terminal) of the GOT with the thickest and shortest cable as possible.
➠
5 - 4
5.2 EMC Directive Requirements
GS2110-WTBD
GS2107-WTBD
Connection type
For the details of each connection type, refer to the following manual.
➠
GOT2000 Series Connection Manual (GT Works3 Version1) for the controller used
When connecting the GOT to other controllers such as a non-Mitsubishi PLC, fabricate connection cables and configure the
system following the EMC Directive specifications.
➠ ■4.
Non-Mitsubishi PLC, inverter, and servo amplifier connections
POINT POINT POINT
Connected devices
When connecting the GOT to a non-Mitsubishi PLC, refer to the manual about the EMC Directive
compliance of the connected device (such as a PLC and a microcomputer).
7.2 Wiring Inside and Outside the Panel
Model
○: Compliant with EMC Directive, ×: Not compliant with EMC Directive
*1
GS21
○
○
○
*2
○