Backup/Restore; System Configuration - Mitsubishi Electric GOT SIMPLE GS2110-WTBD User Manual

15.8.2

System configuration

This section describes the system configuration for the backup/restore function.
For connection type settings and precautions regarding the communication unit/cable and connection type, refer to the
following.
➠
GOT2000 Series Connection Manual (Mitsubishi Products) for GT Works3 Version1
■1. Target controller
Controller
*1*2*3
QCPU(Q mode)
LCPU
*4
FXCPU
*1 Excluding the Q12PRHCPU, Q25PRHCPU.
*2 Use a PLC CPU with the function version of B or later.
*3 The backup/restore function cannot be used with the redundant CPU.
*4 To restore the backup data containing a special parameter, use the following version of CPU.
• FX3U(C) version: 3.10 or later
• FX3G(C) version: 2.00 or later
■2. Connection type
This function can be used in the following connection types.
Name
Backs up setting data for a controller

Backup/restore

connected to the GOT and restores the data
to the controller.
*1 The LCPU does not support the connection type.
*2 When the GOT is connected to LCPU, use L6ADP-R2.
*3 Backup/Restore cannot be used when using CC-Link IE field network Ethernet adapter.
*4 The restoration cannot be performed to a QCPU with the factory-settings or whose memory is formatted.
■3. Required hardware
The backup / restore, SD card is required.
■4. Data to be backed up and restored
The following shows data to be backed up and restored.
Data other than the the following data cannot be backed up and restored.
(1) Basic model QCPU
Item
Parameter
Intelligent function
module parameter
Sequence program
SFC program
*1
File register
Device comment
Device initial value
*1 The file register in the Flash card installed in the CPU is always restored without confirming saving.
Select whether restoring or not the file register stored in the SRAM card or standard RAM in the dialog box displayed when
restoration is executed.
When the file register is not restored, the existing file register is deleted.
Therefore, programs of the controller may not work normally.
If a problem occurs in the operation of the controller after restoration, perform the restoration again, including to the file register.
Function
Description
Parameter for operating a programmable controller
Parameter for intelligent function modules
Program that the CPU operates
Sequence program with the SFC programming format
Data stored in file registers
Device comment to be stored in a programmable controller
Setting the device initial value
( : Applicable,
Connection type between GOT and controller
Direct CPU Computer link
connection connection
*2
Description
15.8 BACKUP/RESTORE
: Partly restricted, : Inapplicable)
Ethernet
connection
*4 *3*4
File name
PARAM.QPA
IPARAM.QPA
MAIN.QPG
MAIN-SFC.QPG
MAIN.QDR
MAIN.QCD
MAIN.QDI
15 - 41
15