Installing When Starting The Got; Installing Using The Data Control Function (Utility) - Mitsubishi Electric GOT SIMPLE GS2110-WTBD User Manual

18.1 Installing when starting the GOT

(1) When installing with an SD card
Step 1.
Power OFF the GOT, and install the SD card where the BootOS, system application or project data is
stored in the SD card interface of the GOT.
Step 2.
Power on the GOT.
While touching the lower right side of the GOT screen, power on the GOT. (1-point press installation
function)
Step 3.
The BootOS or system application is installed in the built-in flash memory.
Do not pull out the SD card or power OFF the GOT.
Step 4.
The GOT restarts automatically after the installation is completed.
Step 5.
After confirming normal restart, confirm that the SD card access LED is not lit, and remove the SD card
from the SD card interface of the GOT.

18.2 Installing using the data control function (Utility)

■1. Operation procedure
18 - 2
18.1 Installing when starting the GOT
Touch
[Data copy].
Step 1.
Power OFF the GOT, and attach the SD card
which stores the basic system application and
communication driver to the GOT.
Step 2.
While touching the upper left corner of the
GOT screen, power ON the GOT.
Step 3.
When the screen shown on the left appears,
select the [Data copy].
For details of install, refer to the following.
➠
15.7 Data Copy