Change Existing Device Settings (Parameterization) - Sony Multiscan CPD-1304S Service Manual

8
Example:
If you use the virtual login function as SU3 and select the KMF Live page, you will get the
following information:
In order to view all parameters regardless of their access rights clear the check box Use virtual
login. The page shows the existing parameters now.
This page contains only internally used values and will not be further explained. If you make
changes here, the device rejects the parameterization after transfer.

8.3 Change existing device settings (Parameterization)

In the enSuite database, different types of parameterization are possible. They are described in
greater detail in the online help. This operating instructions only refers to the adjustment of the
preset factory settings.
Upon delivery, a factory parameterization (device parameterization) is always
present. If necessary, it only needs to be adjusted.
If you deviate from the factory settings, please note that you must always be
logged in for your changes or their transfer to the device and remember the
following:
Only parameter changes that the logged in user is permitted to execute may be
made. Non-editable parameters are listed in gray in the parameter lists and are
labeled with the symbol
Display (see parameterization window left part below)
If you have the necessary rights to use the display editor you can modify
device displays. This documentation describes the structure of the displays in
the delivery state. Since the change of display is not provided, this shall not be
discussed in this operating instructions.
Furthermore, a distinction is made between Offline parameterization and Online
parameterization. These terms and the differences are also explained in the online help and are
taken up below.
Page 102 of 135
Operation and parameter setting on the PC with enSuite
or are not shown depending on login type.
G a s Q u a l i t y A n a l y z e r GasLab Q2