Change Ip Address And Basic Network Settings At Device - Sony Multiscan CPD-1304S Service Manual

GasLab Q2 displays and operating the device

7.3.8 Change IP address and basic network settings at device

The display Ethernet I/F (ethernet interface) enables logged in users, with appropriate rights, to
change the values of the basis network settings. See following figure and chapter 7.2.6.
If the authorization is missing, this display is only a overview of the corresponding settings.
The IP address and the basic network settings could be redefined, via the
operation panel or via enSuite ( See chapter 8).
Do not change the settings of the Configuration (DHCP Mode) as this function
is only relevant for service and commissioning purposes!
Working steps for finding out /changing basic network settings
1. Login to the device ( See chapter 7.3.6)
Navigate to
2.
Register the settings and select the entry to be changed.
3. Ask your system administrator which parameters are to be changed.
(With the activation of the field, the keypad will be displayed.)
4. Use the embedded keyboard to enter values from system administrator field for field
When you have finished all changes, you have to reboot the device to apply the
changes. Use the on-screen action Ok and Reboot. The modified data will be used
after the restart. See Image.
5.
If you are leaving the page with
GasLab Q2
Figure 7.59: Display I/O with input option
(System) and I/O Overview. Activate action CPU3.
applied, your changes will not be made
G a s Q u a l i t y A n a l y z e r
7
Page 83 of 135