Display Sensor Values - Sony Multiscan CPD-1304S Service Manual

7

7.2.4 Display Sensor values

Behind this icon is a list of values. These are the raw values of the transmitters
or sensors In general, these indicators are used only for service purposes and to
find errors.
You will see a complete list of all sensor values in the following table:
Sensor signal
UIR 1 only for internal arithmetic operations
UIR 2 only for internal arithmetic operations
UIR 3 only for internal arithmetic operations
UIR 4 only for internal arithmetic operations
PI Pressure only for internal arithmetic operations
(Environment + measuring unit [ca. 160m bar])
TSB Temperature sensor block
UW11 only for internal arithmetic operations
UW12 only for internal arithmetic operations
UW21 only for internal arithmetic operations
UW22 only for internal arithmetic operations
PU Ambient pressuret (Internal monitoring)
TP Board temperature (Internal monitoring)
PW1 only for internal arithmetic operations
PW2 only for internal arithmetic operations
TM1 only for internal arithmetic operations
TM2 only for internal arithmetic operations
TB1 only for internal arithmetic operations
TB2 only for internal arithmetic operations
TH1 Housing temperature (Internal monitoring)
Page 58 of 135
GasLab Q2 displays and operating the device
Figure 7.16: Display Q2 Sensor values
Use / Meaning
G a s Q u a l i t y A n a l y z e r
Sensor value range
some 100 mV
Ambient dependent
approx. 70 °C
some 100 mV
Ambient dependent
Ambient dependent
Some mW
around 100 °C
around 68 °C
Ambient dependent
GasLab Q2