Gaslab Q2 Displays And Operating The Device - Sony Multiscan CPD-1304S Service Manual

GasLab Q2 displays and operating the device

7
GasLab Q2 displays and operating the device
After switching on power supply, the device begins the start process. When the start process has
been completed, it provides an overview of the state of the measurement on the screen, which is
also called display. Both LEDs above the display light up continiusly. For normal analysis mode,
it is not necessary to change this view, current values (for part. wet gas) are always represented
here.
Some operating modes called Operation and special functions make it necessary to change into
other displays. You can call the other device functions with there displays from the "Home"
display, the main branch point of the device.
General information and rules are listed below. Their details are explained in the next chapters.
Regardless of the current device display, you only have to select a maxi-
mum of two keystrokes (
display after startup called basic display again. This basic display is the Q2
Main display. It also automatically pops up during longer inactivity of the
operator.
Three types of access are possible:
1. Operation with local panel on device
2. Operation via the remote operation panel
These two types can be used to access all standard device functions; only
result influencing parameters can't be changed.
3. Operation via enSuite
This type of access can be used to operate additional functions like read or
modified parameterizations, archive readouts or watching "Live data and
trending" (further information  See chapter 8).
The following applies for each type of access:
To protect important settings and to simplify the parameterization, the
device has a user management with password protection.
(no passwords assigned upon delivery)
Only one user can be logged in at the same time.
Your own password can be created and changed at any time on the device.
Changes already performed and not yet adopted are discarded after
logging out.
Login, Logout and password changes are written in the logbook of device.
Training and seminars
To facilitate the handling of the measuring device or to use all its individual
options, Elster GmbH offers training courses and workshops. If interested,
please use the contact address on page 3 of this operating instructions.
GasLab Q2
and / or bottom right on screen) to reach the
G a s Q u a l i t y A n a l y z e r
7
Page 45 of 135