F: Option Settings; F: Option Settings; F6: Communication Option Card - YASKAWA Z1000 CIMR-ZU*A Series Programming Manual

1.6 F: Option Settings

1.6

F: Option Settings

u

F6: Communication Option Card

Parameters F6-01 through F6-03 and F6-06 through F6-08 are used for EtherNet/IP and LONWORKS options.
n F6-01: Communications Error Operation Selection
Determines drive operation when a communication error occurs.
No.
F6-01
Setting 0: Ramp to Stop (Use the Deceleration Time Set to C1-02)
Setting 1: Coast to Stop
Setting 2: Fast Stop (Use the Fast Stop Time Set to C1-09)
Setting 3: Alarm Only (Continue Operation)
n F6-02: External Fault from Comm. Option Detection Selection
Determines the detection method of an external fault initiated by a communication option (EF0).
No.
F6-02 External Fault from Comm. Option Detection Selection
Setting 0: Always Detected
Setting 1: Detection during Run Only
n F6-03: External Fault from Comm. Option Operation Selection
Determines drive operation when an external fault is initiated by a communication option (EF0).
No.
F6-03 External Fault from Comm. Option Operation Selection
Setting 0: Ramp to Stop
Setting 1: Coast to Stop
Setting 2: Fast Stop
Setting 3: Alarm Only (Continue Operation)
n F6-06: Torque Reference/Torque Limit Selection from Comm. Option
Selects whether torque reference and torque limit values are assigned to the drive from the network.
No.
F6-06 Torque Reference/Torque Limit Selection from Comm. Option
Setting 0: Disabled
Setting 1: Enabled
n F6-07: NetRef/ComRef Function Selection
Selects the treatment of multi-step speed inputs when the NetRef command is set.
No.
F6-07
70
Parameter Name
Communications Error Operation Selection
Parameter Name
Parameter Name
Parameter Name
Parameter Name
NetRef/ComRef Function Selection
Setting Range
Setting Range
Setting Range
Setting Range
Setting Range
YASKAWA SIEP YAIZ1U 03B YASKAWA AC Drive – Z1000 Programming Manual
Default
0 to 4
Default
0, 1
Default
0 to 3
Default
0, 1 0
Default
0, 1 0
1
0
1