Connections And Settings; Connecting To A Nonlinear Editing System (Av/C Connec- Tion) - Sony PDW-D1 Operation Manual

Professional disc drive unit

Hide thumbs Also See for PDW-D1:

Table of Contents

3-2 Connections and Settings

3-2-1 Connecting to a Nonlinear Editing System (AV/C

connection)

3-2 Connections and Settings

By connecting this unit to a nonlinear editing system with an AV/C

(Audio/Video Control) connection, you can transfer video and audio

signals (AV/C data).

The following figure shows an example connection.

Notes

• The S400 (i.LINK) connector of this unit outputs video/audio

signals in DVCAM format. Data recorded in MPEG IMX format is

output after being converted into DVCAM format.

• The nonlinear editing system to be used being connected to this

unit requires editing software (not supplied) supporting DVCAM

format.

• Use the Utility Software (see page 46) to make the following

settings before transferring video/audio signals (AV/C data) from

this unit to a nonlinear editing system.

Audio mode selection

Use setup menu item "DV OUT AUDIO MODE" to select either

of the following.

2ch: 48 kHz/16 bits/2 channels (Factory default setting)

4ch: 32 kHz/12 bits/4 channels

Audio output channel selection

Select the audio output channels with setup menu item "DV

AUDIO OUTPUT SELECT."

For information about how to make setup menu item settings, see 5-3-2 "Setup

Menu" on page 50.

Table of Contents