Power Preparations; Using Ac Power; Using A Battery Pack - Sony PDW-D1 Operation Manual

3-3 Power
Preparations
This unit can be powered by a battery pack
or AC power.

3-3-1 Using AC Power

Connect a power cord (not supplied, see
page 58) to the AC power inlet connector
(page 28) on the rear panel of the unit.
3-3-2 Using a Battery
Pack
Usable battery packs
The battery packs usable with this unit are
as follows.
BP-L60S, BP-GL65, BP-GL95, BP-
M100
To use a battery pack, the optional BKP-
L551 battery adaptor is required.
Note
If the AC power supply and battery pack
DC power supply are both present
simultaneously, the unit operates from AC
power.
To attach a battery pack
Refer also to the Installation Manual for the BKP-
L551 battery adaptor.
Proceed as follows.
1
Using a Phillips screwdriver, remove
the screws from the battery adaptor
attachment section on the side panel of
this unit.
2
Take out the hexagonal wrench from
the back of the battery adaptor.
3
Using the hexagonal wrench, remove
the attachment and battery spacer
which are fixed to the back of the
battery adaptor.
4
Using the hexagonal wrench, screw the
battery adaptor to this unit, and
connect the DC power cord to the DC
power inlet connector on the rear panel
of this unit.

3-3 Power Preparations

33