Philips 32PF9968/10 Service Manual page 26

更多难得资料请到江南家电维修论坛免费下载！
http://bbs.520101.com
EN 26 5. Q523.1U LA
Rewrite Pacific register 0x03 (output format) :
this command is sometimes not processed properly by the
Pacific at initialisation time , resending it here solves the issue.
The higher level requirement is that
audio and video should be demuted
without transient effects and that the
audio should be demuted maximum 1s
before or at the same time as the
unblanking of the video.
Service Modes, Error Codes, and Fault Finding
Wait until previous on-state is left more than 2
seconds ago. (to prevent LCD display problems)
Switch on the display by sending the
PanelConfig.PanelOn (I²C) command to the Pacific
wait 250ms (min. = 200ms)
Switch off the dimming backlight feature and
make sure PWM output is set to 100%
Switch on LCD backlight
Wait until valid and stable audio and video , corresponding to
the requested output is delivered by the AVC AND the
Release audio mute and wait 100ms before any other audio
handling is done (e.g. volume change)
Restore dimming backlight feature, PWM output and unblank
Figure 5-6 "Semi Stand-by" to "Active" flowchart non DFI (50/60 Hz) preheat
Semi Standby
Assert RGB video blanking
and audio mute
backlight PWM has been on for 1second.
Switch Audio-Reset low and wait 5ms
the video.
Active
action holder: AVC
action holder: St-by
autonomous action
Initialize audio and video
processing IC's and functions
according needed use case.
H_16770_110.eps
290307