Table of Contents
Advertisement
APPENDIX D:
USING THE FASTRAK 30 WORKSTATION'S RS-232-C
EMULATION MODE TO RUN THE DIAGNOSTICS
This appendix explains how to use RS-232-C emulation in the
Fastrak 30 Workstation's ROM to run the diagnostics and describes
some input considerations regarding this minimal implementation.
HOW TO ENTER RS-232-C EMULATION MODE
To enter RS-232-C emulation mode:
1.
Connect the Fastrak 30 Workstation to the System 6300
computer with an RS-232 cable.
2.
Depress the space bar while at the same time powering on
the Fastrak 30 Workstation.
B,C,E,F,M,R,S,T:
3.
Type E.
mode.
4.
Boot the diagnostics.
program identifies itself.
SOME INPUT CONSIDERATIONS
Some input considerations for using RS-232-C emulation mode are
as follows:
1.
Do not use the SHIFT, LOCK, CODE, or BACKSPACE keys.
2.
Do not use the function, control, or cursor control
keys.
3.
The numeric keypad generates only the shifted
punctuation characters.
The diagnostic can be run with the restricted character set
described above.
alphabetic characters.
diagnostic is available either in this character set or has the
The Fastrak 30 Workstation enters emulation
After loading, the diagnostics
The diagnostic program is case insensitive to
Nonalphanumeric input that controls the
The following menu appears:
D—1
Advertisement
Table of Contents
