Test Output - Motorola System 6300 Service Manual

Disk Error on write: response=x.
Disk Error on Read Track: response=x.
Read Track time out.
Invalid mode switch.

Test Output

Output for the floppy disk drive subtests follows.
Output for Subtest 1
DISK TEST Floppy
(Subtest 1) Recal Disk.
Output for Subtest 2
DISK TEST floppy
(Subtest 2) Format Disk.
Do you want to format the Floppy disk (erasing contents)?^
Give # of Cylinders (RETURN = default of 80):
Give # of Tracks per Cylinder (RETURN = default of 2):
Give # of Sectors per Track (RETURN
Cylinders = 80, Tracks = 2, Sectors = 8
Give Pack Name (RETURN = default of Floppy):
Give Density (RETURN = default of 2):
Give Step Rate (RETURN = default of 0):
Give Size of Partition 0 (RETURN = default of 640):
Do you want a Loader (Answer [Y/y] or [N/n]:^
Give start Logical Block (RETURN = default of 2):
Give size in Blocks (Default = 12):
Do you want a Dump Area (Answer [Y/y] or [N/n]:n
Do you want a Down Load File (Answer [Y/y] or [N/n]:n
Do you want a Bootable Program (Answer [Y/y] or [N/n]:^
Do you want it in the Reserved Area (Answer [Y/y] or [N/n]:^
Give start Logical Block (RETURN = default of 14):
Give size in Blocks (Default = 200):
Give Interlace Factor (Default = 1):
The Bad Block Table contains 0 entries.
The Bad Block Table contains 0 entries.
Tests and Subtests
default of 8):
—
2-13