Motorola System 6300 Service Manual page 3

PREFACE
This manual describes diagnostic tests for use in manufacturing
and field servicing the Motorola System 6300 Computer, which
contains one 68010 processor board.
You can select an entire test or an individual subtest, or add
new tests and subtests.
combinations of specific tests and subtests, execute using a
single command.
Section 1 of this manual describes how to load and run the
diagnostics. In addition, Section 1 describes the interactive
help feature, special hardware.requirements, and the error
reporting modes.
Section 2 describes each test and its subtests in detail.
Section 2 also discusses error output and notes the parameter
values that you specify to run each test.
section provides a complete list of errors and output for each
test.
Section 3 describes how an experienced programmer adds a new
test.
Section 4 describes the general error conditions that can arise
when any of the tests are executing.
Appendix A provides a list of test sequences that include
multiple tests.
Appendix B provides output for the default test sequence.
Appendix C recommends a sequence for testing the System 6300
Computer.
Appendix D describes how to use the RS-232-C emulation in the
Fastrak 30 Workstation's read only memory (ROM) to run
diagnostics when the Fastrak 30 Workstation cannot be downloaded
from the Winchester disk drive (for example, prior to
installation).
In addition, test sequences, which are
In addition, this
iii