The Diagnostic Command
The commands that run diagnostics specify
•
The test sequences, tests, or subtests to execute.
•
The number of times each test sequence, test, or subtest
executes, and in which order.
•
The error reporting mode.
The command syntax for running a simple diagnostic is as follows:
[RepeatCount][:]Test[,Subtest][L/C]
where
RepeatCount
:
Test
,SubtestNumber
Running the Diagnostics
is a positive integer that
specifies the number of times the
diagnostic named in the command
executes.
is either a colon (:) or a period
(.) if the next parameter is an
integer.
A period is required if
the Fastrak 30 Workstation's RS-
232-C ROM emulation is used.
is either a letter that specifies
the test sequence to run or is a
positive integer that specifies
the number of the test to run.
If this parameter is an integer,
a colon (:) always precedes.
is a positive integer that
specifies the individual subtest
to run.
This parameter is
allowed only if the previous
parameter is an integer not a
letter).
If SubtestNumber is 0
(the default), the entire test
specified executes.
and subtest numbers are
specified, the required delimiter
between the integers is a comma
(,).
If both test
1-7