Suzuki SY413 Service Manual page 3407

8) Remove clutch pulley with puller.
NOTE:
Be careful not to damage pulley when tapping clutch
pulley.
1. Puller
2. Compressor
9) Remove circlip by using special tool (C).
10) Remove clutch coil from compressor.
Special Tool
(C): 09900-06107
1. Circlip
2. Clutch coil
3. Compressor
INSTALLATION
1) Install clutch coil.
Protrusion on under side of clutch coil must match hole in com-
pressor to prevent movement and correctly locate lead wire.
2) Using special tool (C), install circlip to compressor as shown.
Special Tool
(C): 09900-06107
1. Circlip
2. Clutch coil
3) Clamp covering portion of read wire.
3. Compressor
4) Install clutch pulley.
a) Set clutch pulley squarely over clutch pulley installation
boss.
b) Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
Special Tool
(D): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.
1. Clutch pulley
AIR CONDITIONING (OPTIONAL) 1B-13