Table 10-2: Controller Types For Machine Configuration File Templates - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
10 Configuration
Templates for configuration files
In addition to the standard machine configuration files, separate templates for
machine configuration files can be created. The following general conditions must
be fulfilled:

The file extension must be .MCF.

The files must contain a [GLOBAL] section with a machine type key that
corresponds to the selected controller type.

Table 10-2: Controller types for machine configuration file templates

Template file Machine type
Dncmastd.MCF Serial
...
SIN840DStd.MCF SINUMERIK840D
DNCFSStd.MCF File system
!
Important
The templates must be stored in the ...config/template directory.
The standard system includes the following three template files:

Dncmastd.MCF etc.

SIN840DStd.MCF

DNCFSStd.MCF
FBDN1/10-166
Remark
For serial transmission without protocol
For SINUMERIK*
For transmission to network drives
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07