DNC IFC SINUMERIK - Downloading NC Data via a Network (FBDN2)
5 Configuration file
5.2.1 Basic settings
Fig. 5-2: Configuration user interface / Basic settings
The basic settings for the download or upload and operation on the PCU are
defined in the Basic settings tab.
Transfer target switchable via softkey
This parameter specifies whether the default transfer target for the download from
DNC can be switched via a Select softkey:
Checkbox activated = Select softkey available
Checkbox deactivated = Select softkey not available
Extract from the configuration file:
Section [GLOBAL]
ToggleSK = Y
Target
This parameter specifies the default transfer target for the download from DNC:
PCU = The NC data is transferred to the file system
NCK = The NC data is transferred to the NC and loaded
Extract from the configuration file:
Section [GLOBAL]
DefaultTransfer = PCU
FBDN2/5-40
(Y)
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
(N)
05.07