Install The Finishing Materials; Attach The Safety-In-Operation Warnings - Superior Fireplaces DRT3035DEN-C Installation And Operation Instructions Manual

Innovative Hearth Products
DRT3000-C Series Direct-Vent Gas Fireplaces

Install the Finishing Materials

20.
1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished
wall, position framework to accommodate the thickness of the
finished wall.
NOTE: See Cold Climate Insulation on Page 11 and Vent
Termination Clearances on Page 13.
Attach the Safety-in-Operation Warning Labels
21.
1. Attach the furnished safety instruction labels at all fireplace
operation and control points (Page 47).
NOTE: The installer MUST ensure these warnings are properly
attached during installation. The warning labels are a critical
means of informing consumers of safe operation practices.
46
Figure 37 - Combustible Wall Framing
Combustible Finished
Wall Materials
Stand Off Must Be Bent
To Vertical Position
Standoff Provides Space
From Combustible Materials
Hood
Installation
900966-00B, 04/2019
This Area Must
Remain Clear
of Combustible
3"
Materials
(77 mm)
1" Min.
(26 mm)
Top Of Appliance
4" Clearance Minimum