Accessing Control Compartment - Superior Fireplaces DRT3035DEN-C Installation And Operation Instructions Manual

Innovative Hearth Products
DRT3000-C Series Direct-Vent Gas Fireplaces
Burn-in Period
The first few times this fireplace is operated, there will be an odor from the curing of paint and the burning off of the
lubricants used in the manufacturing process. Depending on usage, the burn-in period may take a few hours or a few
days.
NOTE: Ventilate the site during the burn-in period. The resulting odor and haze may set off a smoke detector. Do not
operate the blower during the burn-in period.
A white film may develop on the glass front during the first few fires as part of the burn-in period. The glass
should be kept clean during the burn-in period to prevent the film from baking on—making it very difficult to
remove (Cleaning the glass door on Page 65).
Accessing the Control Compartment
Removing the Control Compartment Door
1. Open the lower access panel by pulling at the top of the door.
2. Pull the hinge pin towards the middle of the fireplace to release the access panel and lift it up and away from the
fireplace (Figure 38A and 38B).
3. Store the panel in a secure location until reinstallation.
Figure 38A - Control compartment
Barrier
Support
Bracket
Magnetic
Latch
Figure 38B - Magnetic latch & barrier support bracket
Hinge Pin
(Pull to
Release)
Barrier
Support
Bracket
Magnetic
Latch
Operation
900966-00B, 04/2019
53