Superior Fireplaces DRT3035DEN-C Installation And Operation Instructions Manual page 64

Innovative Hearth Products
DRT3000-C Series Direct-Vent Gas Fireplaces
Installing the glass door
1. Visually inspect the gasket on the backside of the glass door.
2. Position the door in front of the firebox opening with the bottom of the door held away from the fireplace at a
3. Let the bottom of the glass door swing gently in towards the fireplace ensuring that the gasket seats evenly
4. Install the barrier.
5. Close the control compartment door.
Removing the glass door
1. Open the control compartment door
2. Remove the barrier. Place the barrier in a safe location for later reinstallation.
3. Detach the two (2) door latches beneath the firebox floor.
4. Swing the bottom of the glass door away from the fireplace to a 45° angle (Figure 62)
5. Carefully grip the door at the top and bottom, and remove it from the fireplace. Place the door in a safe location
Figure 62 - Glass Door
The door should easily close without needing to be pressed down. If it has to be pressed
down to close, the gasket in the top of the door should be dressed so it lays on the glass.
Figure 63 - Barrier
64
NOTE: The gasket surface must be clean, free of irregularities, and seated firmly. Ensure it is properly located.
Make sure the bead is not rolled into the channel at the top of the door, but remains flat against the top of the
glass.
45° angle (Figure 62). Hook the top flange of the door frame over the top of the firebox frame.
NOTE: Ensure the glass door is centered—with even spacing on each side.
as the door draws shut. Securely fasten the two (2) latches beneath the firebox floor to the door V-flange.
IMPORTANT NOTE: The door must close without force. When installed properly, the bottom of the door should
not have interference with the fireplace in order to close. If it does, remove the door and inspect the door gasket
to ensure it is even and not rolled up at the top. SEE WARNING IN FIGURE 62.
for later reinstallation.
SEE WARNING BELOW
Glass
Door
Latch
NOTICE: All DRT3000-C series fireplaces require a
barrier (provided) to reduce the risk of burns from the
hot viewing glass. The barrier must be installed prior
to operation.
Replacement barrier catalog numbers are shown here.
1
Gasket
Inside view
of glass door
showing
proper gasket
positioning
INSPECT GASKET AND ADJUST IF NECESSARY (see pictures above)
(1) Ensure the gasket is properly positioned, and area to keep clear, is as shown.
(2) Inspect gasket after installation to ensure it appears as shown above.
NOTE: When installing the glass door, ensure the spacing on both sides is even and equal.
WARNING
35" Barrier - Cat. No. F1839
40" Barrier - Cat. No. F1840
45" Barrier - Cat. No. F1903
900966-00B, 04/2019
2
Gasket
With door installed,
ensure gasket is po-
sitioned as shown.
Operation