Superior Fireplaces DRT3035DEN-C Installation And Operation Instructions Manual page 59

Innovative Hearth Products
DRT3000-C Series Direct-Vent Gas Fireplaces
Installing the DRT3000-C 40 Series Log Set
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log placement is
critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the flames. Follow the log placement
instructions precisely.
NOTE: Do not cover the burner ports.
Table 31 - Log Set
I.D.
Description
No.
1 Rear Log
2 Bottom Left Log
3 Middle Ember Log
4 Right Twig Log
5 Left Twig Log
6 Middle Twig Log
2
1. If necessary, remove the glass door (Pages 63-64).
2. Tear the glowing embers into dime size pieces. Place glowing embers as shown in Figure 46.
3. Locate and bend up the log placement tabs (Figure 47).
4. Place the Rear Log(1) on to the back left tab (b) and the right side tab (e) (Figures 47 and 48).
Figure 46 - Place Glowing Embers (rockwool)
Do NOT place embers on or close
to large ports or the pilot area.
Figure 47 - Locate and bend up the log placement tabs
b
Tab for
Log #2
a
Catalog number for the entire set: See Page 77.
1
4
5
3
Tabs for
Log #1
d
c
e
Tabs for
Log #3
5
2
6
NOTE: Enough glowing ember material
is provided for several applications. For
best glowing effect, replace the ember
material annually.
Figure 48 - Place Rear log (1)
Pin for Log (6)
Fits over Tab "b"
(Figure 47)
900966-00B, 04/2019
1
4
6
3
1
Fits over Tab "e"
(Figure 47)
Bottom View
Operation
59