Level I Programming - P Values - Pentair Pro Elite Professional Series Operation Manual

Level I Programming – P Values
Pressing the SET key will enter the change mode at "Time
of Day". The change mode will be entered at the displayed
parameter if the control is in data mode when the SET key
is pressed. The displayed parameter will flash. Pressing
the Up or Down key will change the flashing value of the
parameter. Holding the UP or DOWN key will scroll the
flashing parameter value. Pressing the SET key again will
enter the flashing value in the appropriate parameter and
advance to the next parameter.
P# Description
P1 Time of Day
P2 Day of Week
P3 Time of Regen
P4 Calendar Override
Day of Week
P5
Regeneration
P6 Salt Setting
Capacity of Unit
P7
(Demand Only)
P8 Hardness of Water
Notes: (1) Calculated depending on salt setting and resin volume.
20 • PENTAIR Pro Elite Professional Series Pro Elite Demand Instruction Manual
Minimum
Range
Increments
1:00 - 12:59
AM or PM 1 Min
00:00 - 23:59
N/A 1 Day
1:00 - 12:59
AM or PM 1 Min
00:00 - 23:59
0 - 99 1
N/A 1 Day
3-18 1
50-290 10
1 - 900 1
0.1 - 90.0 0.1
3 - 200 1
30 - 2000 10
Default Units
Range dependent on value selected
12:00 PM Hr./Min.
for P10. Clock mode.
Uses arrows under days of week on
None N/A
overlay.
Range dependent on value selected
2:00 AM Hr./Min.
for P10. Clock mode.
0 = No calendar override.
0.5 = Regeneration twice a day at time
of regeneration and 12 hours later.
3 Days Calendar Override skipped if at least
one Day of Regeneration selected.
Can be locked out of changes in Level
I Programming.
Uses bars under days of week on
overlay. Day of Week Regeneration is
None N/A
skipped if calendar override is more
than zero.
9 Lbs/Cu ft Unit of measure depends on value in
3
110 g/L P9. Units of Measure.
Kilograins Unit of measure depends on value in
(1)
Kilograms P9. Units of Measure.
Grains per
25 Gallon Unit of measure depends on value
250 Milligrams selected for P9. Units of Measure.
per liter
Notes