Displays, Icons And Cursors; Button Functions - Pentair Pro Elite Professional Series Operation Manual

Displays, Icons and Cursors

Figure 13
Note: In normal operation and during programming,
only a few of the icons will actually be displayed.
1. Used to select and indicate the actual Day of the
Week setting.
2. This cursor is displayed when programming the Days
Override.
3. PM indicator displayed when setting Time of Day and
Time of Regeneration. Note: There is no AM indicator.
4. Indicates displayed value in minute increments.
5. Indicated kilograins or kilograms when estimated
capacity is displayed.
6. Used to display "P", "H", and "C" parameter.
7. Indicates access into "H" Level IV History viewing.
8. Indicates access into "P" Level ll programming.
9. Used to display cycle position during regeneration.
Also indicates access into "C" Level III cycle
programming.
10. This cursor is displayed during Level l programming:
Time of Day, Regen Time, Day, Salt, etc.
11. When flashing, this indicates regeneration is to occur
at next Time of Regen. Appears as a solid icon during
regeneration.
12. When hourglass is flashing, this indicates that the
control is moving to a regeneration cycle. Appears as
a solid icon during a cancelled regeneration and the
control is cycling directly back to the home position.
13. Indicates the selected program setting has been
locked out. Lock settings are changed in Level II
programming.
14. Indicates double regeneration.
Time/Day
Regeneration Time/Day
12
Salt Amount
11
8
Capacity
10
Hardness
9
14
13
WE TH FR SA DAYS
SU MO TU
x2
C
P
H
7
6
18
15. Normally off. Will glow red if salt brine is not reaching
the valve during recharge. Indicates out-of-salt
condition.
16. Maintenance display turns on if the months in service
exceed the value programmed in P11 "Service Interval".
17. When Lbs/ft
3
amount entered is in pounds per cubic foot.
18. X100 multiplier for large values.
19. When "g/L" is displayed the valve is in grams per liter.

Button Functions

DOWN
arrow
DOWN and UP Arrows: Used to scroll through settings or
change setting value.
SET: Used to enter a setting into memory or activate a
setting to be changed.
REGEN: Used to command the control to regenerate and
enable or disable lockout setting.
PENTAIR Pro Elite Professional Series Pro Elite Demand Instruction Manual • 17
1
2
3
PM
4
MIN
g/L
17
KG
5
x100
16
3
Lbs/ft
19 15
is displayed, the value for regenerant
UP arrow
SET
For Regeneration
Figure 14