Commissioning And Diagnostics - Siemens SIMATIC ET 200S Manual

Commissioning and Diagnostics

Configuring the IM 151-7 CPU with STEP 7
This chapter describes how to configure an ET 200S for the IM 151-7 CPU with
STEP 7.
Resetting the memory of the IM 151-7 CPU
In certain situations you must reset the memory of the IM 151-7 CPU. This chapter
describes these circumstances and the procedure for resetting the memory of the
CPU component.
Diagnostic options
The ET 200S distributed I/O system is designed to make handling and
commissioning as simple as possible. If a fault or an error should occur in spite of
this, you can analyze it using the LEDs, the slave diagnosis and the diagnostic
options in STEP 7.
Interrupt evaluation
To help you evaluate the interrupts of the ET 200S, we will examine the difference
between these and the interrupts of the S7/M7 DP master and other DP masters.
Chapter overview
In
Section
7.1
7.2
7.3
7.4
7.5
7.6
7.7
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
Configuring the IM 151-7 CPU
Resetting the memory of the IM 151-7 CPU
Commissioning and startup of the IM 151-7 CPU as an I slave
Diagnostics using LEDs
Diagnostics via diagnostic address with STEP 7
Slave diagnostics with IM 151-7 CPU used as an intelligent slave
Diagnostic data of the electronic modules
Contents
7
Page
7-2
7-4
7-7
7-9
7-12
7-15
7-25
7-1