Getting Started - Siemens SIMATIC ET 200S Manual

Getting Started

Introduction
This guide takes you through the 10 commissioning steps required to set up a
functioning IM 151-7 CPU application by running through a concrete example. In
this way, you will get to know the basic functions of your IM 151-7 CPU for the
following:
S Hardware and software
S Stand-alone operation (MPI)
S Intelligent DP slave (PROFIBUS-DP)
Prerequisites
You must be familiar with the fundamentals of electronic/electrical engineering and
have experience of working with computers and MicrosoftR Windowst
95/98/NT/2000.
Danger
!
The IM 151-7 CPU, the ET 200S and the S7-300 are used in installations and
systems that require you to comply with specific rules and regulations that vary
depending on the application.
Please note the relevant safety and accident prevention regulations, such as
IEC 204 (emergency stop systems).
Non-compliance with these regulations can result in serious injury and damage to
both machinery and equipment.
Chapter overview
In
Section
2.1
2.2
2.3
2.4
2.5
2.6
2.7
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
1st step: Installing the IM 151-7 CPU (ET 200S) and S7-300
2nd step: Wiring the IM 151-7 CPU (ET 200S) and S7-300
3rd step: Commissioning the IM 151-7 CPU (ET 200S)
4th step: Configuring the IM 151-7 CPU for stand-alone operation
(MPI)
5th step: Programming the IM 151-7 CPU
6th step: Test Run
7th step: Changing the IM 151-7 CPU to an I slave and
commissioning of the S7-300
Contents
2
Page
2-3
2-4
2-6
2-7
2-9
2-10
2-11
2-1