Siemens SIMATIC ET 200S Manual page 39

Configure the S7-300-CPU as follows:
Se- Action
quence
1 In the SIMATIC Manager, select the project
Getting Started in the left-hand part of the
window.
2 Insert the new S7-300 station into the project as
described in step 4, point 3.
3 In the SIMATIC Manager, click on the S7-300(1)
station in the left-hand part of the window.
4 Double-click on the Hardware symbol in the
right-hand part of the window.
5 If no catalog is shown in the right-hand part of the
window, activate it by selecting the command
Catalog in the View menu.
In the catalog, navigate through SIMATIC 300 to
Rack 300.
Drag and drop a mounting rail into the top
left-hand window.
6 Insert the PS whose order number matches the
order number of your PS, at slot 1 as described
in step 4. Repeat for the S7-300-CPU (slot 2), the
S7-300-DI (slot 4) and the S7-300-DO (slot 5).
Note:
S
A window appears when the S7-300-CPU is
inserted. In this window, select "PROFIBUS
Network" and set the address to 2.
Confirm with OK.
ET 200S IM 151-7 CPU Interface Module
A5E00058783-04
Result
The Hardware symbol appears in the
right-hand part of the window.
The Editor used to edit the hardware
opens.
Configuration example (may differ from
your configuration):
Getting Started
2-13