System Messages - Garmin G5 Pilot's Manual

Other battery indications:
Battery charger hardware fault, or temperature too high or low to
charge the battery safely
Battery fault
Battery is not present
4

SYSTEM MESSAGES

The following table shows G5 system messages that may appear along the bottom of the display. These
messages remain while the condition persists or until cleared by pressing the knob.
Message
External Power Lost
Critical battery fault!
Powering off...
Battery fault
Battery charger fault
Low battery
Hardware fault
Power supply fault
Unit temperature limit
exceeded
Network address
conflict
Communication error
Factory calibration
data invalid
Magnetic field model
database out of date
Using external GPS
data
Garmin G5 Part 23 AML STC Pilot's Guide
Meaning
Aircraft power has been removed from the G5
Battery has critical fault condition and the unit is about to power off to
avoid damage to the battery.
Battery has a fault condition - contact Garmin if it persists.
Battery charger has a fault condition - contact Garmin if it persists.
Battery charge level is low
Unit has a hardware fault - contact Garmin for service
Unit power supply fault detected - contact Garmin for service if it persists
Unit is too hot or too cold
Another G5 with the same address is detected on the network (most
commonly a wiring error on one of the units)
General communication error (most commonly appears in conjunction
with Network Address Conflict message)
Unit calibration data not valid - return to Garmin
Internal magnetic field database is out of date - software update required
GPS data from another network LRU is being used. The unit's internal
GPS receiver is enabled, but unable to establish a GPS fix
Page 16 of 16
190-01112-12
Rev. 1