Samsung DCS-816 Programming Manual page 127

SAMSUNG
DCS-816
AA INT DGT TIME:
AA NO ACT TIME:
AA TRANS TIME:
ALERT TONE TM:
ALM REM INTERVAL: This timer controls the time length between ring attempts
alarm reminder ring (1
ALM REM RING OFF:This timer controls the length of the ring cycle when alarm
ATT RECALL TIME:
E–hold ße–hold recl timeà recall to ß att recallà recall toßrecallà disconnect
U–hold
transfer transfer recall
AUTO REDIAL INT:
press RETRY
when busy/rback interval
AUTO REDIAL RLS:
BARGE–IN TONE
INT:
RECALL WAIT TIME
SMDR START/DP
SMDR START/DTMF
SYS HOLD RECALL
TRANSFER RECALL
UCDS AUDIO ALARM
UCDS VISUAL ALAM
PERI UCD REPORT
TIMER DESCRIPTIONS
sys hold recall
ßauto redialà 1st auto ßauto redialà 2nd auto
15 SEC
30 SEC
15 SEC
45 SEC
20 SEC
0 SEC
0 SEC
5 SEC
This timer controls the grace period between dialling valid
digits before transferring call to INVLID DEST as set in
MMC 733 on a per–plan basis.
If no digits are received by the AA module, this timer
expires and transfers the call to the destination set in
MMC 733 NO ACT DEST. This timer is usually called as
first digit timer after entering AA mode.
After this time, compare input digit with AA translation
table (MMC 732) and transfer to destination
This timer sets the duration of the attention tone
preceding a call to a keyset in the Voice Announce or
Auto Answer mode. This tone also precedes a forced
Auto Answer call.
at a station when alarm reminder is set.
st
) ßintervalà alarm reminder ring (2
reminder is set at a station.
This is the length of time a transfer recall will ring at a
station before recalling the operator.
originator time
This timer controls the time between attempts after
RETRY dialling is set on a station.
redial
This timer controls the duration of a Ring No Answer
condition on a retry number dialled before the auto redial
is automatically cancelled.
This timer controls the intervals between the tones sent
to the person who is being barged in on.
MMC 501 (Page 3 of 7)
February, 1999
1–255 SEC
1–255 SEC
1–255 SEC
0–255 SEC
0–255 SEC
0–255 SEC
0–255 SEC
3-99 SEC
nd
)
operator disc. time
interval redial
Programming