Print Frame Pattern (Single-Side Printing) (Function Code 69) - Brother DCP-7090 Service Manual

1.3.20 Print frame pattern (single-side printing) (Function code 69)

<Function>
This function is used to print the frame pattern on single side of the paper to check for printing
flaws and omission.
<Operating Procedure>
(1) Set the paper specified in the default paper settings (A4 or Letter) to the paper tray.
(2) Press the [6], and then the [9] in the initial state of maintenance mode. For models
without keypad, press the [▲] or [▼] to display "MAINTENANCE 69" on the LCD and
press the [OK]. "PRINTING" is displayed on the LCD, and the frame pattern (refer to the
figure below) is printed on single side of the paper.
(3) When printing is completed, "WAKU SX" is displayed on the LCD.
(4) Press the [X] or [Stop], and the machine returns to the initial state of maintenance mode.
Note:
If printing fails, printing is stopped with displaying any of the errors shown in the table below.
To retry printing, refer to the "Remedy" in the table below and eliminate the error cause and
press the [Start] or [Mono Start]. "PRINTING" is displayed on the LCD, and the frame pattern
is printed on a single sheet of paper.
Error display
Replace Toner
Cover is Open
No Paper
Jam Tray1
Jam Rear
 Frame pattern
Replace the toner cartridge and press the [Start] or [Mono Start] to
release the error.
Close the Front cover.
Refill the paper, close the paper tray and press the [Start] or [Mono
Start] to release the error.
Remove the jammed paper, then close the paper tray and all
covers, press the [Start] or [Mono Start] to release the error.
Fig. 5-17
5-40
Remedy
Confidential