Brother DCP-7090 Service Manual page 102

 Error code 8E01
Paper size is not set as A4/Letter/Legal/Folio when receiving fax or printing a list/report.
Error code 8E02
Detected that the size of paper set in the paper tray was over 10 mm shorter than paper size
set in the machine during faxing or printing a list or report.
<User Check>
• Set A4 or Letter-size paper.
Step
Registration rear actuator caught
1
in some sections of the machine
2 Registration rear sensor failure
3 Main PCB failure
 Error code 9001
The size of paper loaded in the MP tray and the one specified from the driver are not same
when paper is fed from the MP tray.
Error code 9002
The size of paper loaded in the paper tray and the one specified from the driver are not same
when paper is fed from the paper tray.
<User Check>
• Change the driver setting to be matched with the size of the paper set in the paper tray.
Step
Registration rear actuator caught
1
in some sections of the machine
2 Registration rear sensor failure
3 Main PCB failure
 Error code 9201
When printing from the MP tray, paper type setting in the machine does not match the setting
in the driver.
Error code 9202
When printing from the paper tray, paper type setting in the machine does not match the
setting in the driver.
<User Check>
• Use the same paper type setting for the machine and driver.
Step
1 Malfunction of the main PCB
2 Main PCB failure
Cause
Cause
Cause
2-62
Remedy
Reattach the registration rear actuator.
Replace the actuator holder ASSY.
Replace the main PCB ASSY.
Remedy
Reattach the registration rear actuator.
Replace the actuator holder ASSY.
Replace the main PCB ASSY.
Remedy
Install the latest main firmware.
Replace the main PCB ASSY.
Confidential