Brother DCP-7090 Service Manual page 259

(6) Remove the Taptite bind B M3x10 screw. Release each Hook, and remove the Registration
front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/
rear sensor harness from the Hole.
Registration front/rear actuator
holder ASSY
Hook
Registration front/rear
sensor harness
Registration chute
Hole
Harness routing: Refer to
Assembling Note:
• After assembling the Registration front/rear actuator holder ASSY to the Registration
chute, push the Actuators by fingers and check if they are pushed back by their springs
(if the springs are not caught at assembling).
<Top side>
Hook
Hooks
<Bottom side>
Fig. 3-102
"12. Top side of the registration
Fig. 3-103
3-102
Taptite bind B M3x10
chute".
Actuators
Registration chute
Confidential