Print Frame Pattern (Single-Side Printing) (Function Code: 69) - Brother DCP-1510 Service Manual

1.3.18 Print frame pattern (single-side printing) (function code: 69)

<Function>
This function is used to print a frame pattern on a single side of the paper and to check for
printing flaws.
<Operating Procedure>
Be sure to set letter size paper for test pattern printing before commencing the following
procedure.
(1) Ten-key pad models
Press the [6] and [9] buttons in this order in the initial state of maintenance mode.
Non-ten-key pad models
Press the [
[OK] button.
(2) "PRINTING" is displayed on the LCD, and the frame pattern is printed on a single side of
the paper.
When printing is completed, "WAKU SX" is displayed on the LCD.
Note:
• If printing fails, printing is stopped and one of the errors shown in the table below is
displayed. To retry printing, refer to the "Remedy" in the table below to eliminate the
cause of the error, and press the [Start] button.
(3) To print the frame pattern again, press the [Start] button.
(4) When the [Stop/Exit] button is pressed, the machine returns to the initial state of
maintenance mode.
Error display
LCD
TONER EMPTY
Cover is Open
No Paper
Jam Tray1
Jam Rear
Print pattern
] or [ ] button to display "MAINTENANCE 69" on the LCD and press the
Replace the toner cartridge.
Close the top cover.
Set paper in the paper tray.
Remove the jammed paper.
Remove the jammed paper.
Fig. 4-10
Remedy
4-27
Confidential