Brother DCP-7090 Service Manual page 80

Error message
Upper line
Size Error Specify the correct
paper size for Tray
1.
Size Error 2- Press [OK]. Specify
sided the correct paper
and load the same
size paper as the
Printer driver
setting.
Press Stop[x].
Specify the correct
paper and load the
same size paper as
Printer driver
setting.
Size mismatch Reload correct
paper.
Reload correct
paper in MP Tray,
then press [Retry].
Reload correct
paper in Tray1, then
press [Retry].
Lower line
For printing by feeding paper
from the paper tray, the size of
paper specified from the driver
set the size which was not
supported by the paper tray.
For 2-sided printing, paper size
setting of the printer driver that
was not supported by 2-sided
printing was selected.
The registration rear sensor
detected that the paper fed was
smaller or larger than the
specified size in duplex printing
mode.
Paper size is not set as A4/
Letter/Legal/Folio when
receiving fax or printing a list/
report.
Detected that the size of paper
set in the paper tray was over
10 mm shorter than paper size
set in the machine during faxing
or printing a list or report.
The size of paper loaded in the
MP tray and the one specified
from the driver are not same
when paper is fed from the MP
tray.
The size of paper loaded in the
paper tray and the one specified
from the driver are not same
when paper is fed from the
paper tray.
2-40
Description
Error Refer
codes to:
9702 2-64
9701 2-64
8A01 2-61
8E01 2-62
8E02 2-62
9001 2-62
9002 2-62
Confidential