Table of Contents
Advertisement
Removing Headlight
1. Remove rear and center shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
5. Loosen both nuts (1) and remove headlight with holder
from rubber mounting.
6. Loosen both screws (2) to remove headlight from
holder.
7. Replace headlight.
Installing Headlight
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.
6.11.3 Replacing Headlight (Conventional on Modulite)
•
Size 2 Phillips screwdriver
•
6 mm Allen key
•
Oblique pliers
•
Tie wraps
Removing Headlight
1. Remove rear and center shroud. See 6.8.2 Replacing
Centre Shroud, page 55 and 6.8.1 Replacing Rear
Shroud, page 55.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
1533060-N
Fig. 6-83
Fig. 6-84
Fig. 6-85
Service
77
Advertisement
Table of Contents
