System); Replacing Headlight Complete; Lighting System) - Invacare TDX SP2 Series Service Manual

Invacare® TDX® SP2 Series

6.12.2 Replacing headlight complete

(conventional lighting system)
• Phillips screwdriver size 2
• Oblique pliers
• Cable ties
Removing headlight
1. Remove rear shroud as described in 6.9.2 Replacing
Rear Shroud (Without Operating Hour Counter), page
41.
2. Carefully note location of cable and connection
locations of the various plugs. Either mark each plug
and socket, or take a photograph with a digital camera.
3.
On the illustration you can see lighting PCB B for
power module C, optional cross connector D.
4. Loosen cable leading to lighting PCB from front
headlight affected.
5. Remove all cable ties and pull cable out of mobility
device.
6.
Loosen and remove two screws which hold front
headlight.
7. Replace headlight unit.
Installing front headlight
1. Install parts in reverse order. Route cables carefully
and fix them with cable ties.
2. Test all functions.
6.12.3 Replacing headlight complete (LED

lighting system)

• Allen key 4 mm
• Oblique pliers
• Cable ties
Removing headlight
1. Remove rear shroud as described in 6.9.2 Replacing
Rear Shroud (Without Operating Hour Counter), page
41.
2. Carefully note location of cable and the connection
locations of the various plugs. Either mark each plug
and socket, or take a photograph with a digital camera.
50
3.
In the illustration you can see lighting PCB B, power
module C and optional cross connector D.
4.
Loosen cable leading to lighting PCB from headlight
affected.
5. Remove all cable ties and pull cable out of wheelchair.
6. Loosen screw (1) and remove front bulb from
mounting.
7. Replace headlight.
Installing headlight
1. Install parts in reverse order.
2. Route cables carefully and fix them with cable ties.
Pay attention to 6.10.8 Cable routing, page 45.
3. Test all functions.
4. Tighten all screws finger-tight.
5. Test all functions.
6. Adjust headlight roughly using grid. User can carry out
final adjustment according to user manual.
6.12.4 Replacing front lamp holder
(conventional lighting system)
• Size 2 Phillips screwdriver
• 13 mm socket wrench
Removing front lamp holder
1. Remove complete headlight as described in 6.12.2
Replacing headlight complete (conventional lighting
system), page 50.
2. Loosen and remove screw B and washer.
3. Remove front lamp holder A.
Installing front lamp holder
1. Install parts in reverse order.
2. Test all functions.
1532486-N