Table of Contents
Advertisement
6.11.11 Replacing Rear Light (Conventional)
•
4 mm Allen key
•
8 mm socket wrench
•
13 mm socket wrench
•
Oblique pliers
•
Tie wraps
Removing Rear Light
1. Remove rear and center shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
5. Loosen nut (1).
6. Lift off rear light shroud (2) carefully.
7. Remove two plastic caps (1).
8. Loosen two nuts (2).
9. Remove nut and washers (3).
10. Pull off rear light (6) to the rear and remove protect
cap (5) and both bushes (4).
Installing Rear Light
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Test all functions.
6.11.12 Replacing Rear Light Holder (Conventional)
•
8 mm socket wrench
•
13 mm socket wrench
1533060-N
Fig. 6-105
Fig. 6-106
Fig. 6-107
Service
85
Advertisement
Table of Contents
