Measurement Target - Roland Double Sheet Detector I100 Manual

B0003308 / 1.4 /
13.02.2013
4.2.2

Measurement target

The sensor coverage (measurement target) must be at least the three times sensor diameter. The
dimension x should ideally correspond to the sensor diameter D (see picture below).
If the coverage is smaller, then the sheets should be transferred with reduced speed through the
sensor gap or measured statically. Precondition is however a constant distance to the sheet edge.
Fig. 10: Measurement target
Pos: 20 /Doppelblech/Geräte/R1002/4 Montage/Kabel @ 0\mod_1184847699046_501.doc @ 4110 @ 233
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Manual
Double Sheet Detector R100 I100
for pairs of sensors
D
x
x
Sensor
Mounting
21