Section 3 - Omron Z500 series Setup Manual

• Do not reverse the connections of the signal terminals and COM terminals.
NOTICE
• Using the RESET Signal
Do not input the RESET input immediately after turning ON the power. When using
RESET input to synchronize startup timing, wait at least 1 second after turning ON the
Z500's power supply before turning ON the RESET terminal.
The initial status of the output terminals is OFF. The terminals, however, may turn ON for
CHECK
approximately 0.5 seconds when the power is turned ON.
Be sure to allow for this when connecting to an external device.

SECTION 3

Connecting External Devices
Z500
Setup Manual
43