Basic System Configuration - Omron Z500 series Setup Manual

SECTION 1
Wiring and Connection

1-1 Basic System Configuration

NOTICE
CHECK
Z500
18
Setup Manual
• The following diagram shows the basic Z500 system configuration. Some of the
components shown in the configuration diagram are special OMRON products that cannot
be substituted with comparable devices. These items are indicated with an asterisk.
• Always turn OFF the power supply before connecting or disconnecting cables. The
peripheral device may be damaged if connected or disconnected with the power supply
turned ON.
Sensor
Z500-SW2 (2-m cable)
Z500-SW17 (2-m cable)
Up to 2 Sensors can be connected.
* Sensor Extension Cable
Z309-SC1 (3 m, 8 m, or 13 m)
Specify the required cable length when ordering.