Information Messages - Husqvarna Automower 535 AWD Operator's Manual

6.3 Information messages

The table below shows a number of information messages that may be shown in Automower
Connect. Contact your local Husqvarna representative if the same message appears often. For more
Messages on page 24 .
information, refer to
Message Cause
Low battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored
Confirmation that a
tings has been carried out.
Guide not found
The guide wire is not connected to the
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
38 - Troubleshooting
Action
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 18 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
on page 32 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 39 .
Reset all user set-
This is normal. No action required.
Check that the guide wire's connector
is tightly connected to the charging sta-
tion. Refer to
on page 18 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 18 .
®
To install
Battery
To install the guide wire
1055 - 001 - 04.02.2019