Husqvarna Automower 535 AWD Operator's Manual page 23

• Guide wire - The product moves in the work
area until it finds the guide wire. The product
moves along the guide wire to the charging
station.
The factory setting is set to mix the 2 search
methods. When the battery is low the product
starts to search for the charging station signal.
The strength of the charging station signal can be
changed in the Automower
specified time delay the product changes search
method to the guide wire method. The time delay
can be changed in the Automower
app.
3.13.4.2 Lawn coverage
Lawn coverage function is used to move the
The
product to remote parts of the work area. You
can divide your lawn into 5 areas. For each area
you can set:
• which guide wire the product should follow.
• the distance from the charging station to the
remote area.
• how frequently the product should operate in
the remote area.
3.13.4.3 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the
product moves back into the work area. The
Drive Past Wire function
factory setting for the
function is 31 cm. You can select a distance of
20-50 cm.
3.13.4.4 Starting point
The Starting point function allows you to control
how far the product drives forward from the
charging station before it starts to operate. Use
this function if the charging station is placed in an
area with limited space, for example under a
veranda.
3.13.5 Accessories
Accessories you can change the
In
settings of the product accessories. To
change the settings, obey the
instructions in the Automower
Connect app.
3.13.5.1 Headlights
Headlight settings
There are 4 different headlight settings that
control when the headlights are on:
1055 - 001 - 04.02.2019
®
Connect app. After a
® Connect
®
• Always ON
• Evening only
• Evening and night
• Always OFF
The default setting is Always ON.
Flashes when fault
The headlights flashes if the product stops to
operate because of a fault if the function
when fault is enabled. The default setting is that
Flashes when fault is enabled.
3.13.6 General (Bluetooth
This function is used to set time and
date, or to reset to default settings. To
change the settings, obey the
instructions in the Automower
Connect app.
3.13.6.1 Time & date
The time and date can be changed manually, or
by using the time and date from the mobile
device.
3.13.6.2 Reset to factory settings
The user settings can be reset to factory settings.
3.13.7 Security (Bluetooth
The security settings controls the PIN
code, the GeoFence and other security
functions. To change the settings,
obey the instructions in the
®
Automower Connect app.
3.13.7.1 New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if 2 adjacent
installations have a very similar signal.
3.13.7.2 Change PIN code
The correct PIN-code must be entered to get
access to the Security menu in the Automower
Connect app. To change the PIN code, obey the
instructions in the app.
3.13.7.3 Theft protection
Theft protection menu it is possible to set
In the
the alarm duration and also what events should
trigger the alarm.
Flashes
®
only)
®
®
only)
®
Installation - 23