Replace The Blades - Husqvarna Automower 535 AWD Operator's Manual

5.2.3 Wheels
Clean around the front wheels and rear wheels.
Grass on the wheels can impact on how the
product performs in slopes.
5.2.4 Cover
Use a damp, soft sponge or cloth to clean the
cover. If the cover is very dirty it may be
necessary to use a soap solution or washing-up
liquid.
5.2.5 Charging station
Clean the charging station regularly from grass,
leaves, twigs and other objects that may impede
docking.
WARNING: Use the plug to disconnect
the charging station before any
maintenance, or cleaning of charging
station or power supply.

5.3 Replace the blades

WARNING: Use blades and screws of
the right type. Husqvarna can only
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use
Husqvarna original blades embossed with the
crowned H-mark logotype, refer to
terms on page 49 .
1055 - 001 - 04.02.2019
5.3.1 To replace the blades
1. Switch off the product. Refer to
the product on page 27 .
2. Put on protective gloves.
3. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body.
4. Rotate the skid plate so that its holes align
with the screws for the blade.
Guarantee
5. Remove the 3 screws. Use a manual
straight slot or cross-tip screwdriver.
To switch off
Maintenance - 29