Husqvarna Automower 535 AWD Operator's Manual page 36

Message Cause
Wheel motor over-
The product is caught in something.
loaded
Charging station
The contact between the charging
blocked
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual The product is set to the
charging area operating mode.
Next start hh:mm
The timer setting prevents the product
from operating.
The time on the product is not correct.
Lifted The lift sensor has been activated as
the product has become trapped.
Collision sensor
The product body can not move freely
problem
around its chassis.
Wheel drive prob- Grass or other object is wrapped
lem
around the drive wheel.
Alarm! Mower
The alarm was activated because the
switched off
product was switched OFF.
Alarm! Mower
The alarm was activated because the
stopped
product was stopped.
Alarm! Mower car-
The alarm was activated because the
ried away
product was lifted.
36 - Troubleshooting
Action
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Remove the object.
Turn the product the right way up.
Secondary Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Change the timer settings. Refer to
Timer on page 21 .
Set the time. Refer to
page 23 .
Free the product
Check that the product body can move
freely around its chassis.
If the problem remains, the message
requires action by authorized service
technician.
Clean the wheels and around the
wheels.
Adjust the security level in the
menu, refer to
ly) on page 23 .
Time & date on
Security
®
Security (Bluetooth on-
1055 - 001 - 04.02.2019