Husqvarna Automower 535 AWD Operator's Manual page 35

Message Cause
No loop signal
The boundary wire is crossed on its
way to and from an island.
The connection between the product
and the charging station has been bro-
ken.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
Trapped
The product is caught in something.
The product is stuck behind a number
of obstacles.
Empty battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
No drive The product is caught in something.
The work area includes a steep slope.
The guide wire is not laid according to
the recommendations.
1055 - 001 - 04.02.2019
Action
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
install the boundary wire on page 17 .
Place the product in the charging sta-
tion and generate a new loop signal.
Try moving the boundary wire.
Free the product and rectify the reason
for it becoming trapped.
Check if there are any obstacles which
make it hard for the product to move
away from this location.
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 18 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
on page 32 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 39 .
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Maximum guaranteed slope is 70%.
Steeper slopes should be isolated. Re-
To put the boundary wire in a
fer to
slope on page 14 .
Put the guide wire according to the rec-
ommendations. Refer to To install the
guide wire on page 18 .
Troubleshooting - 35
To
To install
Battery