Husqvarna Automower 535 AWD Operator's Manual page 22

the product is not operating it is parked in the
charging station. The operating hours and days
can been seen in an overview in the Automower
Connect app.
The default timer setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the
work area is less than the maximum capacity the
timer should be used to minimize wear on the
grass and to the product.
To calculate the timer setting, refer to
calculate the timer setting on page 22 .
3.13.1.1 To calculate the timer setting
1. Calculate the dimension of your lawn in m
2
yd .
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note: The operation capacity is approximate and
is calculated for flat and open work area. If the
work area has a lot of slopes or obstacles, you
need to increase the timer settings.
Model Approximate operation ca-
pacity, m
®
Automower 535 146 / 175
AWD
Example: A lawn of 500 m
®
Automower 535 AWD.
2
500 m / 146 ≈ 3.5 h.
2
600 yd / 175 ≈ 3.5 h.
Days / h / day
week
7 3.5
3.13.2 Cutting height
Cutting height you can change the
In
cutting height settings for the product.
To change the settings, obey the
22 - Installation
®
To
2
/
2 2
/ yd / h
2 2
/ 600 yd , cut with an
Timer settings
10:00 - 13:30 / 10
am - 1.30 pm
instructions in the Automower
Connect app.
The cutting height can be varied from MIN (3 cm /
1.2 in.) to MAX (7 cm / 2.8 in.).
CAUTION: During the first weeks after
a new installation, the cutting height
must be set to MAX to avoid damaging
the loop wire. After this, the cutting
height can be lowered step by step
every week until the desired cutting
height has been reached.
3.13.3 Operation
Operation you can change the
In
operation settings of the product. To
change the settings, obey the
instructions in the Automower
Connect app.
3.13.3.1 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.13.4 Installation
Installation you can change the
In
installation settings of the product. To
change the settings, obey the
instructions in the Automower
Connect app.
3.13.4.1 Find charging station
The product has 2 search methods to find the
charging station:
• Charging station signal - The product moves
in the work area until it finds the signal of the
charging station.
®
®
®
1055 - 001 - 04.02.2019