Siemens SINUMERIK 840D sl Operation/Programming Manual page 83

08/2005
2
Cycle Start
Parameter
F, S, V See Sec. "Creating program blocks".
In the left input field of the parameter spindle, you can choose between the main
spindle (S1) and a counter spindle (S3). In the right input field, enter the spindle
speed or the cutting speed.
Machining
type
Position Stock removal position:
Direction Stock removal direction (face or longitudinal) in the coordinate system:
Reference point ¬ (abs)
X0
Z0 Reference point (abs)
End point ¬ (abs) or end point (inc)
X1
Z1 End point (abs or inc)
FS Chamfer (n=1...3) alternative to R
R Radius (n=1...3) alternative to FS
XF2 Undercut (alternative to FS2 or R2)
D Infeed depth (inc) – (only when roughing)
UX Finishing dimension in X direction (inc) – (only when roughing)
UZ Finishing dimension in Z direction (inc) – (only when roughing)
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Press the "Cycle Start" key.
The "Stock removal" cycle is started.
You can return to the parameter screen form at any time to check and
correct the inputs.
Press the "Cursor right" key to jump back to the input screen form.
Roughing
Finishing
Parallel to Z axis (longitudinal)
Outside Inside
X X
Z
X
X
Z
2.8 Manual mode
Description
Parallel to X axis (plane)
Outside
X
Z Z
X
Z Z
Setting Up the Machine
Unit
Inside
X
Z
X
Z
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
2
2-83