Siemens SINUMERIK 840D sl Operation/Programming Manual page 100

Machining the Workpiece
3
3.5 Starting the machining at a specific point in the program
To External -
contour without cal.
...
Cycle Start
Cycle Start
Reset
Searching for any text
Search
Find
next
Start
search run
3-100
Specify target directly
Load a program in "Machine Auto" mode (see Sec.
"Starting/stopping machining").
Press the "Block search" and "Search pointer" softkeys.
Search
pointer
Specify the desired target.
Select a calculation technique.
Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Load a program in "Machine Auto" mode (see Sec.
"Starting/stopping machining").
Press the "Block search" and "Search" softkeys.
Search
Enter the text string that you want to locate.
Select whether the search is to commence at the start of the
program or the current cursor position.
Press the "Search" softkey.
The program block that contains the text string is marked.
Press the "Find next" softkey, if you want to continue the search.
Press the "Abort" and "Start search run" softkeys.
Where chained program blocks have several technology blocks,
select the desired technology block in the "Search run" window
and press the "Accept" softkey.
The prompt does not appear in the case of single program blocks.
For chained program blocks, enter the number for the desired
starting position and press the "Accept" softkey.
The prompt does not appear in the case of single program blocks.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
3
♥ Siemens AG, 2005. All rights reserved